Product Manual

Page 6 of 12
of children. Inspect the tool for good working condition prior to storage and before re-use.
 Use only accessories that are recommended by the manufacturer for use with your product.
Accessories that may be suitable for one product may create a risk of injury when used with
another tool. Never use an accessory that has a lower operating speed or operating pressure than
the tool itself.
 Keep guards in place and in working order. Never operate the product without the guards in place.
Assembly Instructions
⚠WARNING
 Allow the proper clearance between the cutting lips of the bit and points of the chisel.
 Always store chisels and bits when not use, to protect them from damage.
Mounting the chisel holder on the quill:
1. Choose the correct split ring bushing for your drill press. Position the split ring bushing in the
chisel holder (#4) with the flange of the bushing against the top of the chisel holder. Align the slot
against the top of the chisel holder. Align the slot against the bushing with the gap in the chisel
holder.
2. Mount the chisel holder (#4) over the base of the quill. Make sure that the slot in the bushing is
still aligned with the gap in the chisel holder.
3. Secure the chisel holder using the 2 3/8’’ screw (#15) and the hex nut (#5).
4. Insert the bit through the chisel and into the chuck. Position the chisel with the bit slot facing to the
left or tighten the drill press.
5. Push the bit up until the bit is against the chisel. Secure the bit in the chuck.
6. Loosen the knob (#6) holding the chisel. Push the chisel up against the chisel holder eliminating
the 1/32’’ gap. Tighten the knob (#6).