Product Manual

Page 6 of 12
sizer may be required. Adjust the lamp head to the desired position.
Before Each Use
⚠WARNING
Solar lights require sunlight to function properly. Extended periods of cloudy weather will cause
shorter run-times. Shade on the solar panel is to be avoided. The solar panel may be cleaned with a
clean, damp cloth. Do not use soap, solvents, or abrasives.
A regular visual inspection is recommended. Ensure the solar panel is free from debris and in a
location where it will receive several hours of sunlight each day. Ensure the light is facing the desired
direction and that there are no nearby alternate light sources that may interfere with the light sensor.
Operating Instructions
1. Before the light can operate to its full capacity, allow the unit to charge in sunlight for 3 days with
the solar panel wire connected to the light. Charging should be done with the unit in the OFF
position.
2. Located at rear of the solar panel there is an OFF/AUTO switch:
 AUTO position - The light will turn on automatically when there is no longer ambient light.
Typically this happens just after dusk. If the light does not turn on at dusk, check for other
light sources that may be interfering with the sensor.
 OFF position - The light will remain off and will not turn on during the day or night. This
position can be used when the light is in storage or needs to be charged.
Choosing the Location of the Light
Solar powered lights require sunlight to
recharge the internal batteries. For best results, place the solar panel in a position where it will receive
direct sunlight, generally free from cover and shade.