Product Manual

Page 5 of 26
(5) Manual start button
Manually start LS4 switch, the same function as PP strap interpolation.
(6) Manual feeding button
Press this button when the green light is on, the straps can be fed manually. While retracting strap, press this
button will reset the machine.
NOTE: This machine can automatically switch off after a while of inactivity and restart as the strap is inserted.
2. INSTALLATION OF THE STRAP COIL (as shown in Fig. 3)
1. Screw off the hand wheel and take off the front strap reel.
2. Place a coil of strap on the back strap reel with correct direction allowing the shaft to poke through the plastic
wrap. Make sure the straps wheel inner diameter clip in reel center claw.
NOTE: Install the strap coil with the right direction, so that the reel will turn clockwise when the strap is pulled off.
(Refer to FEEDING STRAPS section as stated below)
3. Replace the front strap reel and reinstall the hand wheel.
Fig.3 Strap Coil Installation