Product Manual

Page 4 of 26
START-UP
1. INTRODUCTION TO THE CONTROL PANEL
The control panel is at the upper right corner of the machine front plate (see Fig.2).
(1) Power switch
Turn on the switch (position I), then the red light is on and you can operate the machine.
Turn off the switch (position O), cut down the power, then the machine stops.
(2) Tension force adjustment knob
Turn the knob clockwise to enlarge tension force. Larger tension force, faster the speed of retreat strap.
Note: When the tension force is large, operate carefully and avoid hurt from PP strap.)
(3) Cooling time knob
Turn the knob clockwise to lengthen the cooling time. The larger the tension force is, the longer cooling time
you should set.
(4) Length adjustment knob
Rotating the knob can adjust the feeding length of the straps automatically, so that you can set up a standard
length of the strap to fit the same packages. Each scale is about 500mm. Turn the knob clockwise to enlarge
the feeding length of the straps.
Fig. 2 Control Panel
Fig. 1 Installation Dimension