Product Manual

Page 2 of 26
2. Do not place the machine on the slant place.
3. Do not move the machine when machine is running.
4. Do not place the machine on the wet or dusty place. Keep it clean and dry.
5. Properly ground the machine before operation. There is danger of electric shock when it does not connect to
the ground wire or does not connect fully.
6. The sectional area of the extended flexible wire should be over 2 mm² and the length should be within 10m.
The flexible wire beyond this scope can damage the machine, and can cause fire due to hot plug and socket.
7. Wear eye or face, and hand protection. Do not wear loose clothing.
8. Keep hands or other parts of the body out of the strap chute area during operation.
9. The temperature of the heater plate is very high. Do not touch.
10. Do not insert strap while there is not a package on the operation table.
11. Do not replace any safety parts of different specifications.
12. Shut off all electric power after machine operation or servicing machine.
13. Do not use water or steam to clean the machine.
14. Do not remove the electric control box cover if not necessary. Only trained engineers are allowed to open the
electric box. Before opening, be sure to pull the power plug off.
15. The machine is used for strapping products or packages only.
16. Do not take off the panel, cover, door and other parts to use the machine. Taking off the parts will cause
machine faulty and easy to cause human injury.
17. Do not modify the machine. Use the modified machine will cause human injury.
18. Do not put the wire on the passageway of forklift. Once the coat of wire is damaged or the wire is broken, it
will cause danger.
19. Do not insert or pull out attaching plug with wet hand to avoid shocking danger.
20. Do not use the machine to strap wet products.
21. Make sure pull out the plug if the machine is not in use.
22. Do not put inflammable materials around the machine if the heater is in high temperature.
23. Keep this operation manual at your strapping machine. Refer to it often.
The following warning signs can not be removed or replaced randomly. They are labeled in the positions
that will cause danger to human body. The power supply MUST be cut off before repair the machine.
①. Warning sign 1 is used for heating positions. Do not touch the mechanical parts with the sign in case of
scalding.
Warning Sign 1
②. Warning sign 2 is used for the electric parts. It indicates danger of electric shock inside the machine after
the door is removed.