Product Manual

Page 11 of 26
reassemble the middle knife.
LS2
B
A
LS1
后顶刀
调整
前顶刀
中刀
MAINTENANCE AND LUBRICATION
The machine requires periodic maintenance and lubrication. Do not keep the product in the wet and moist place in
order to prevent the danger of fine or electrical damage. Always keep it dry.
The material of the strap is PP, which is easily out of shape if in high temperature and fire. Please do not place the
strap near the inflammable and explosive products. If the strap is bend or out of shape, the machine may appear
trouble and cannot strap normally. Cleaning and lubricating is important measures to prolong its service life. The
strap powder and slices can be caused by friction during the strapping and usually gather in space between
machine head and electrical component. The powders must be cleaned up in time, at least once a week. (Cut off
the power supply during cleaning.)
WARNING: Only trained or professional personnel can service the machine. Make sure the machine is cool
and the wire plug has been disconnected before servicing.
1. On a weekly basis, clean out the rubbish in the machine.
 Move the machine panel, use the air gun to blow the dust and use lubricant to clean the inside parts listed
below.
 The moving place of up and down slide board.
 Electric heating head moving place.
 The inside of the hole of three knifes.
 Check all of the spring tension force to see if adjustment is required.
 Check if the store strap balancing pole is flexible through the simple moving.
 Check how to strap with some cartons, please be careful with the default, which can see and hear and
check the correct running.
2. On a monthly basis (or strap 100000 times cycles),
 Check if the bolt of mechanism is flexible.
 Check if the roller of feeding strap is flexible.
Adjustment
Rear point knife
Front point knife
Middle point knife
Fig. 10 Knifes