Product Manual

Page 7 of 22
Set up the Tripod Base (1):
 Set the base on the floor, resting it on the casters (4).
 Press down on the slide yoke (5) ring. Hold the ring down while you swing the two outer legs
(3) out until the yoke snaps back into place into the locking hole on the bottom of the slide
tube.
 To prevent the tripod base (1) from rolling backward during assembly, lower the backstop tip
(7) as shown.
 Set the frame assembly (9) onto the two "V" angles on the tripod base (1), and lower the
frame (9) about 1 inch until it is secured by the angles. Before continuing, be sure the frame
(9) is pushed all the way down and is held securely by the angles.