Product Manual

Page 14 of 22
 To Raise the Panel:
Crank the winch wheel (19) in the direction shown (hold the post for leverage) until the panel is at
the desired height. The brake (22) is spring-loaded to automatically hold the cradle at the selected
height when you stop cranking.
 To Lower the Panel:
 Grasp the wheel handle with your right hand so you can restrain the backward rotation of the
winch.
 Retain your hold on the winch handle. Carefully release the brake with your left hand and
slowly rotate the wheel backward to lower the cradle to the desired height.
Extension Accessory--#57476 (sold separately)
To install the accessory and remove the Standard Telescoping Sections:
 Release the cable tension until you can loosen the cable from the mooring tab in the winch. Pull
the cable out through the hole in the winch drum.
 With large pliers, grasp the top end of the two telescoping sections and lift them out of the frame
housing as a unit. Pulling the free end of the cable toward the winch wheel will help raise the
telescoping sections.
 Remove the telescoping sections (and the cable) completely out of the frame housing.