Product Manual

Page 12 of 22
Slide the Yoke Ring (5):
Press down on the slide yoke ring to unlatch the two forward legs so they can be rotated out to
the hoist’s working position or in to its storage position. A spring-loaded pin snaps into a hole on
the bottom of the slide tube to lock the folding legs into position.
Using the Backstop (7):
Pivot the backstop down to prevent the base from rolling backward, or up to allow the unit to
wheel freely.
Outriggers (29):
The outriggers on the cross arms (48) extend for supporting a longer drywall panel.
To extend an outrigger, pull out the lock pin with your right hand until you can slide the outrigger
out with your left hand.
Panel Support Hooks (49):
Open the support hook on each cross arm (48) to support the drywall panel when it is being
loaded, or when the cradle is tilted. To avoid damaging them, always close the support hooks
before transporting or storing the hoist.
Slide Bar Lock (15):
The slide bar lock holds the winch assembly at its operating (fully extended) position.