Product Manual

Page 11 of 22
 Press each cross-arm (48) forward into the socket until the spring tab on the bottom of the
cross-arm (48) snaps into place.
Before Each Use
⚠WARNING
 Inspect the unit carefully for wear or damage. Pay special attention to the cable.
 Be sure the hoist is at working room temperature before operating.
 Be sure the winch brake drum is clean and dry before operating.
Operating Instructions
⚠WARNING
 To avoid injury, slide bar lock must be fully engaged if winch assembly is extended.
 Wear ANSI Z87.1 compliant safety goggles, hard hat, heavy duty gloves, and steel toed boots
during setup and use.
 Do not exceed the rated load capacity.
 Do not use to transport people or pets.
 Secure load before raising or lowering load.
 Only use the hoist to raise and lower one panel at a time.
 Never load a drywall panel or operate the hoist if the lock pins are not engaged at one of the three
positions.
 Use ONLY for lifting a drywall panel.
 To avoid serious injury, watch for overhead obstructions when raising panel.
 Cradle drops rapidly when brake arm is released.
 Control the winch with your right hand on wheel handle BEFORE releasing brake.