Product Manual

Page 8 of 23
Frame Assembly
Set the frame assembly onto the two "V" angles on the tripod base. The frame must fit over both
"V” shaped flanges. The frame assembly must sit exactly vertically. If the frame sits at an angle
then the unit is not tucked into the inner "V” shaped flange.
Winch Wheel Set-up
1. Attach the handle (49) to the wheel (36). Tighten the nut and then back it off slightly so the handle
(49) turns freely.
2. Move the wheel to the working position:
• Check that the casters are locked before beginning.
• Hold the brake handle (34) in your left hand and the wheel in your right hand. Rotate the
wheel (29) counter-clockwise while you lift the brake arm to release the brake.
• Pull the winch wheel slightly back toward the frame and rotate the slide bar lock clockwise to
engage, securing the winch wheel into the working position.