Product Manual

Page 16 of 23
• Crank the winch wheel clockwise to raise the panel slightly, then stop, checking that the
brake is functioning properly. Slide the secure square pin through the inner pin holes above
the telescoping section.
• If the brake is functioning properly, resume raising the panel to the desired height. Slide the
secure square pin through the inner pin holes above the telescoping section.
⚠CAUTION
The wire ropes must be aligned and wound tightly and evenly on the spool to prevent tangling. If they
start winding unevenly, lower the load and carefully adjust them before continuing.
To Lower the Cradle:
• Push and hold the winch wheel slightly forward to support the weight of the cradle.
• Turn the latch handle counter-clockwise and push the handle to move the latch tongue away
from the lock holes. To lower the cradle, operate the brake handle with your left hand and
rotate the winch wheel counter-clockwise with your right hand.
⚠CAUTION
Do not release control of the wheel handle as the hoist is lowering or the cradle may lower forcefully
and cause injury.
After Each Use
⚠WARNING
Always store the hoist in a dry, protected area.
Completely lower the cradle and clean all surfaces of the hoist with a clean cloth.