Product Manual

Page 14 of 23
Attached Pin with Pin Level
This is a self-locking device. When lifting a panel, the latch is automatically locked and avoids the
sudden fall of the cradle. This is a second insurance against the cradle falling. If the attached pin fails
to work, this Secure Square Pin will limit the falling height of the cradle.
To raise the cradle, turn the latch handle counter-clockwise and then push the handle to move the
latch tongue to the holes of the telescoping section. Slide the Secure Square Pin through the inner
pin holes above the telescoping section.
To lower the cradle, turn the latch handle counter-clockwise and then push the handle to move the
latch tongue away from the lock holes.
Winch Wheel (36)
The winch wheel is used to raise and lower the cradle, which holds the panel. This is done by means
of a wire rope which wraps around a spool in the winch.
⚠CAUTION
⚫ Pay attention to the action of the wire rope when operating this tool. Do not allow your hands,
clothing, hair, or jewelry to come near the wire rope. If these become caught in the wire rope you
can be injured. Do not allow the wire rope to become tangled or jammed during operation.
⚫ Align the wire rope and wind it tightly and evenly on the spool to prevent tangling. If they start winding
unevenly: stop, reverse direction to loosen the rope, and then carefully adjust them before
continuing.