Product Manual

Page 10 of 23
3. Press each crossarm (42) forward into the socket until the spring tab on the bottom of the cross-
arm (42) snaps into place.
Testing the Assembly
1. With assembly completed, check the panel hoist to be sure all fasteners are tight, the wire
rope is in place and undamaged, and the hoist is safe to use.
2. Check the tripod base to be sure it is firmly attached to the frame. Be sure the legs are firmly
extended and locked in place.
3. Check the frame and winch to be sure they are properly installed and functioning properly.
4. Check that the cradle is properly attached to the frame.
5. Check that the crossarms are firmly attached to the cradle.
6. Raise and lower the cradle, while checking for proper function, before operating the hoist with
a load.