Product Manual

Machine Components

1. Hose Wrap. The hose wrap is built into the tank and provides a storage location for the gun hose

2. Gun Hose. The gun hose transfers chemical from the pump to the spray gun.

3. Fill Cap. The fill cap has a vent to allow air to enter the tank as the chemical is dispensed.

4. Sprayer Pump. The sprayer pump makes the chemical flow to the spray gun and out the nozzle.

5. Suction Tube. The suction tube is the inlet line for the pump. The suction tube has a suction strainer to

prevent debris from entering the pump.

6. Spray Gun. Use the spray gun to apply chemical to specific areas. The spray pattern is adjustable from

stream to cone by twisting the spray nozzle (see Operation Instructions). When the remote switch is in

the ON position, the spray gun trigger is the pump ON/OFF control. Squeeze the trigger and the pump

turns on, let go and the pump turns off.

7. Gun Clips. Use the gun clips to store the spot spray gun.

8. Sprayer Tank. The sprayer tank holds the chemical.

9. Pump Power Cord. The cord connects the sprayer pump to the remote switch. It should be

disconnected when the sprayer is not in use.

10. Remote Switch. The remote switch connects the battery to the pump power cord and allows the

operator to turn the sprayer pump on and off. The remote switch may be left connected to the battery

when the sprayer is not in use.

11. Spray Nozzle. Spraying pattern adjusts from stream to cone.

12. Fill marks. Molded into tank.