Product Manual

Assembly

Step 7: Connect remote switch to battery (battery not included)

WARNING

Batteries are hazardous because they contain caustic acid, can emit explosive

gases, and can cause electric shock.

Caution must be exercised when making connections to a battery to avoid shock

and contact with the acid, and to prevent any sparking that could lead to an

explosion.

ALWAYS follow the safety instructions and steps listed below in exact sequence

when connecting the sprayer's wire harness to the battery terminals.

1. Preparatory

safety

Preparatory safety steps:

• ALWAYS use eye protection

• NEVER smoke or work near sparks or other sources of ignition.

• NEVER touch both battery terminals at the same time or with any non-

insulated tools.

• If battery acid contacts skin or clothing, flush immediately with water and

neutralize with baking soda.

2. Connect remote

switch to

battery

Connect the sprayer’s remote switch to the vehicle battery, or a U1 lawn and

garden battery using the following procedure:

a) Disconnect the battery ground wire (if using a vehicle’s battery).

b) Connect the remote switch’s red battery clamp to the positive (+) terminal

of the battery.

c) Connect the remote switch’s black battery clamp to the negative (-)

terminal of the battery.

d) Reconnect the battery ground wire (if using a vehicle’s battery).

WARNING: Always connect in this sequence to avoid possible shock.

3. Connect remote

switch to pump

power cord

Connect the remote switch to the pump power cord:

Note: Make sure the power switch is in the OFF position on the remote switch.

4. Verify

connection

Verify a complete connection has been made by checking with a DC voltmeter,

or by briefly turning the remote switch to the ON position and listening for pump

activation.

5. Attach remote

switch to vehicle

Using supplied Hook & Loop pad, affix remote switch to vehicle in a position

that is easily reached.

Pump power cord

Remote switch