Product Manual

Page 11 of 19
Figure 2
• Remove the pull-tab from the grease cartridge and screw the grease tube assembly clockwise
into the gun.
• To release the follower rod, depress the follower key and push the follower rod forward into the
grease tube assembly. Purge the air from the pump. See the Purging Air Pockets section.
Filling the Gun from a Bulk Container
• Rotate the grease tube assembly counter-clockwise to unscrew the grease tube assembly from
the gun.
• Insert the open end of the grease tube assembly into the bulk container. Depress the follower key
and slowly pull back on the follower handle while pushing the grease tube assembly deeper into
the lubricant to prevent air pockets from being pulled into the grease tube assembly.
• When the follower rod is fully extended (approximately 8 inches), the grease tube assembly is
full. Release the follower key to hold the follower rod in its extended position.
• Screw the grease tube assembly clockwise into the gun. To release the follower rod, depress the
follower key and push the follower rod forward into the grease tube assembly. Purge the air from
the pump. See the Purging Air Pockets section.
• Clean any excess grease from the gun body.
Operating the Grease Gun
• Fully insert the charged battery pack into the grease gun. See Figure 3.
• Connect the high-pressure hose coupler to the grease fitting, and ensure that the coupler is
squarely seated on the fitting. See Figure 4.
• Squeeze the trigger switch to activate the grease gun. Grease should now be dispensed through
the high-pressure hose coupler and into the grease fitting. See Figure 5.