Product Manual

Page 15 of 29
6. Install the chuck
6.1 Tilt the chuck guard to the open position and push the chuck onto the spindle.
6.2 Using a wood mallet, firmly tap the chuck upward into position on the spindle shaft.
7. Install the depth stop assembly (not included)
Slide the end of the threaded rod through the bracket on the side of the head, then through the
hole in the top of the chuck guard. Secure it with the nut provided, from beneath, thereby locking
the depth stop to the chuck guard fixed on the Spindle.
Therefore, as the spindle is moved downwards, the depth stop will move by the same amount.
The pointer may be zeroed by sliding it up or down on its mounting.
8. To reduce the risk of unintentional starting, make sure the power switch is OFF before plugging
the drill press in to power. Also make sure the power circuit for the press meets the machine’s
requirements and has a properly grounded outlet.