Product Manual

Page 13 of 29
Assembly
For your own safety, do not try to plug in the drill press until it is completely assembled and installed
according to the instructions and until you have read and understood this instruction manual.
 To avoid injury from unexpected starting, do not plug the power cord into a power source
receptacle during unpacking and assembly. This cord must remain unplugged whenever you are
assembling or adjusting the machine.
 If any part is missing or damaged, do not plug the machine in until the missing or damaged part is
replaced, and assembly is complete.
 To protect the machine from moisture, a protective coating has been applied to the machined
surfaces. Remove this coating with a soft cloth moistened with kerosene.
1. Unpack the shipping carton; check contents to verify all the parts listed below are present.
1. Head assembly
X1
7. Chuck guard assembly
X1
2. Base
X1
8. Depth stop assembly
X1
3. Table assembly
X1
9. Feed handles
X3
4. Table locking handle
X1
10. Hex wrench
X1
5. Chuck
X1
11. Hex bolt
X3
6. Chuck key
X1
12. Column assembly
X1
NOTE: If your machine is provided with a self-tighten chuck, the chuck key is not necessary and not provided.