Product Manual

Page 20 of 28
2. Positioning the Workpiece
To prevent the workpiece or backing piece from tearing from your hands while drilling, you MUST
position it against the LEFT side of the column. Failure to do this could result in personal injury.
3. Using a Vise
For a small workpiece that cannot be clamped to the table, use a drill press vise. The vise
must be clamped or bolted to the table.
A drill press vise, if used, MUST be clamped or bolted to the table to avoid injury from a spinning
workpiece or damage to the vise or bit parts
4. Correct Drilling Speeds
Use the recommended speed for the drill bit and workpiece.
Recommended Operating Speeds for twist drill bits ( 1/min )