Product Manual

Page 17 of 28
2. Feed Depth Adjustment
Lower the spindle assembly to a desired depth and turn down the adjust nut. Turn down the lock
nut against the adjust nut to lock it in place. The drill is now set to drill holes to this predetermined
depth. The depth scale shows the maximum depth a hole can be drilled.
3. Speed Adjustment: this drill press has 5 speeds shown in the speed label.
a. To change the speed, loose the belt tension lock knob.
b. Pull the motor to the front end then change the belt placement on the desired pulley.
c. To tighten the belt, push the motor to the rear end and lock the belt tension lock knob.
4. Quill Spring Adjustment
The quill return spring may need adjustment if the tension causes the quill to return too rapidly or
too slowly.
4.1 Loosen nuts A and B making sure that the spring housing C remains engaged with head casting.
Lock nut
Adjust nut