Product Manual

Page 16 of 28
Before Each Use
To avoid injury from accidental starting, always turn the switch OFF and unplug the drill press before
installing or removing any accessory or attachment or making any adjustment.
Make the following adjustments before each use of the drill press.
1. Table adjustment
A. Height adjustment
Loosen the table bracket locking handle then adjust table to the desired position. Retighten the
locking handle.
B. Tilting adjustment:
Loosen the hex bolt below the table. Rotate the table to the desired angle shown on the scale.
Tighten the hex bolt to secure the table tilt.