Product Manual

Page 13 of 28
Assembly
For your own safety, do not try to plug in the drill press until it is completely assembled and installed
according to the instructions and until you have read and understood this instruction manual.
• To avoid injury from unexpected starting, do not plug the power cord into a power source
receptacle during unpacking and assembly. This cord must remain unplugged whenever you are
assembling or adjusting the machine.
• If any part is missing or damaged, do not plug the machine in until the missing or damaged part is
replaced, and assembly is complete.
• To protect the machine from moisture, a protective coating has been applied to the machined
surfaces. Remove this coating with a soft cloth moistened with kerosene.
1. Unpack the shipping carton; check contents to verify all the parts listed below are present.
No.
Description
Qty
No.
Description
Qty
1
Head assembly
1
6
Chuck key
1
2
Table locking handle
1
7
Feed handles
3
3
Table assembly
1
8
Hex wrench
1
4
Base
1
9
Hex bolt
3
5
Chuck
1
10
Column assembly
1
NOTE: If your machine is provided with a self-tighten chuck, the chuck key is not necessary and not
provided
.