Product Manual

Page 18 of 30
 Always disconnect the air supply after use so that oil can't leak out in case one of the pump's
components should break.
 Keep the pump in a dry and cool place out of the reach of children. Pumps are delivered in
appropriate cardboard boxes. Packaging material should be properly disposed.
 Handling and storage of the new pump does not require any special procedures, however after
the pump has been used, empty the used oil in the suction tube into an appropriate container.
This is done by overturning the pump.
 The dust in compressed air can slow down and even block the motor cylinder. The following
steps may prevent this from happening:
 Add 50 grams of appropriate lubricating oil to the air inlet hole weekly; operate the pump for
several minutes after adding oil.
 Turn on the pump for several minutes until moving parts are fully lubricated.
 You may repeat the above operation if necessary. These steps should be carried out on a
weekly base.
 For the pumps that are attached with compressed air treatment equipment, empty the water
retained in the reservoir of the filter-purger frequently.
 For the pumps that are attached with a lubricator, pay close attention to the lubricator's oil level
and refill with SAE 20, SAE 30, or antifreeze oil for extreme conditions when necessary.
 How to clean the pump: Operate the pump and drain off the oil, then the pump can be used with
another oil.
Maintenance
The user should perform only routine maintenance operations (filters, silencers, cleaning) to avoid
damaging the unit or compromising the user’s safety. Contact our sales or service centers when the
pump needs further maintenance.