Product Manual

Page 17 of 30
Dispensing Procedure
Note: Before you begin, make sure you understand how to unlock the trigger.
1. Pull the trigger toward the valve body to open the valve and begin dispensing.
2. Lock the valve open by keeping the trigger squeezed and depressing the trigger lock button. Then
release the trigger, releasing your forefinger from the trigger lock last.
3. Pull the trigger toward the valve body to release the trigger lock. The trigger lock disengages.
Release the trigger to stop dispensing.
Operating the Hose Reel
1. Check reel for correct operation by slowly pulling out the hose. A clicking sound will be heard
every half revolution of the drum.
2. To latch the reel, pull out the hose and allow it to retract after hearing the first second or third
click.
3. To unlatch, slowly pull out the hose until the clicking sound stops, then let the hose retract until
the hose stop rests against the hose guide.
Note: To avoid damage to the reel, always hold on to the hose while it is rewinding.
4. Periodically check the hose condition for wear or damage, and check the swivel fitting for leakage.
Replace any worn, damaged, or leaking parts.
Adjusting the Spring Tension
1. Pull out approximately 6ft (2m) of hose and allow the drum to latch.
2. Remove hose stopper from hose, and feed hose back through guide.
3. Wrap the pulled hose one time around the drum to increase tension or un-wrap hose one time
from drum to decrease tension.
4. Re-insert hose through guide, and install stopper onto hose end.
5. Unlatch the drum and check tension. Pull hose from reel, and adjust stopper position if necessary.
Replacing the Swivel Seal
1. Turn off and disconnect supply line from swivel inlet.
2. Remove swivel assembly from reel axle.
3. Remove circlip from swivel, and take apart.
Note: You may want to remove swivel from reel hose end, but this is not necessary unless a new
swivel is being installed.
4. Replace the seals and reassemble swivel.
5. Use Teflon type or thread sealant on swivel thread fitting, reconnect the swivel thread fitting with
axle.
6. Re-connect inlet supply line.
Replacing the Hose
1. Turn off supply to reel.
2. Pull out all the old hose and lock the reel in this position.
Note: Make sure reel drum is securely locked and cannot rotate back.
3. Remove two hose clamps from hose.
4. Carefully disconnect hose from swivel joint on side of reel, or male fitting in axle center and
remove old hose.
5. Feed new hose through guide and opening in drum, and connect to swivel. Re-install two hose
clamps, on inside and outside of drum flange. Install stopper on other end of hose in the same
position as before.
6. Carefully release the drum latch, and slowly allow the hose to wind onto the reel.
Note: Final spring adjustment is accomplished by adding or removing wraps of hose around the drum
(see spring tension adjustment).
After Each Use
⚠WARNING