Product Manual

Page 12 of 30
Digital Installation:
Fig. 1 shows a typical installation.
The installation shown in Fig. 1 is only a guide. The components shown are typical; however, it is not
a complete system design. Contact your distributor for assistance in designing a system to suit your
particular needs.
Pre-Installation Procedure
1. Relieve the pressure.
1. Close the fluid shut-off valve (item 4 in Fig.1).
2. Ground the hose and reel or console. Do not use PTFE tape on the pipe joints; it may cause a loss
of ground across the pipe joint.
Installation Procedure
If this is a new installation, or if the oil in the lines is contaminated, flush the lines before you
install the dispense valve.
Fig. 1
1: Air inlet 2: Air shut-off valve 3: Oil pump 4: Fluid shut-off valve
5: Meter 6: Hose reel 7: Control valve