Product Manual

Page 10 of 30
Reference
Subassembly
Quantity
213
U seal
1
214
Guiding
1
215
O-ring
1
216
Quick coupling
1
Assembly Instructions
When the pump is connected to the compressed air supply:
• The compressed air must be filtered to avoid dust into pump.
• The max compressed air pressure must not exceed 115 psi.
• To deliver oil, press the knob on the delivery gun; delivery stops when the knob is released but
the whole system remains under pressure.
• Position the gun so that the circuit can't open accidentally. Otherwise oil could leak onto the
ground.
• Never point the gun at people or animals.
• Press the gun knob only after you are sure that the gun is in the right place so that the oil doesn't
leak onto the ground.
• Always cut off the air supply after use so that oil can't leak out in case one of the pump's
components should break.
• Use only original spare parts in case the pump has to be repaired or its components have to be
replaced.
• Ensure the tightness of all joints and screwed connections.
• When there is no load, cut off compressed air to stop pump.
PUMP INSTALLATION
• When the pump is applied to a high viscosity oil, or used in low temperature, an oil follower plate
is recommended to avoid air pockets and to get the most out of your oil.
• The follower plate, which is pulled towards the bottom of the drum by suction pressure produced
by the air operated pump, compresses the oil, preventing the formation of air pockets which may
cause a blockage in delivery.
• The follower plate will always keep the oil clean to preserve its characteristics and also enable
the oil to be collected from the bottom of the drum to avoid waste.
• Loosen the bung adaptor or wall bracket adaptor star nut. Slide the bung adaptor off of the
suction tube.
• Carefully place the pump through the bung adaptor and the follower plate. Then tighten the star
nut firmly in order to attach the pump.
CONNECTION OF THE AIR INLET LINE
• Air inlet connection is 1/4'' quick coupling (or 1/4'' NPT female) in all versions.
• Compressed air connection (to be supplied by the customer) should be done using suitable
tubes.
• A compressed air treatment unit (filter and regulator) is recommended to be attached to the
pump. In order to improve the efficiency of the pump, the installation of a lubricator is also
recommended.