Product Manual

Page 6 of 12
and perform its intended function. Replace damaged or worn parts immediately. Never operate the
product with a damaged part.
• Do not use a product with a malfunctioning switch. Any power tool that cannot be controlled with
the power switch is dangerous and must be repaired by an authorized service representative
before using.
• Disconnect the power/air supply from the product and place the switch in the locked or off position
before making any adjustments, changing accessories, or storing the tool. Such preventive safety
measures reduce the risk of starting the tool accidentally.
• Store the product when it is not in use. Store it in a dry, secure place out of the reach of children.
Inspect the tool for good working condition prior to storage and before re-use.
• Use only accessories that are recommended by the manufacturer for use with your product.
Accessories that may be suitable for one product may create a risk of injury when used with
another tool. Never use an accessory that has a lower operating speed or operating pressure than
the tool itself.
• Keep guards in place and in working order. Never operate the product without the guards in place.
• Do not leave the tool running unattended.
Specific Operation Warnings
⚠WARNING
• Electric shock hazard. DO NOT expose the unit to water.
• Risk of electric shock. Connect to a properly grounded outlet equipped with a Ground Fault Circuit
Interruption device (GFCI).
• Risk of fire. DO NOT operate in areas with flammable fumes. The fumes can spark, igniting fumes.
• DO NOT use the unit with any Solid-State Speed Control Device.
• DO NOT run the cord under carpeting. DO NOT cover the cord with throw rugs, runners, or similar
coverings.
• DO NOT route the cord under furniture or appliances. Arrange the cord away from traffic area and
where it will not be tripped over.
• DO NOT exceed 12 amps through the attached GFCI outlet.
• DO NOT allow more than 2 identical air movers (item #73032) to be connected to each other at
one time.
• DO NOT use an extension cord.
• Disconnect from the power supply before servicing.
• DO NOT block the air inlet or exhaust.
• DO NOT modify the grounded plug.
• DO NOT use if the cord or other parts are damaged.
• Ensure the power switch is off prior to plugging the air mover in power supply.