Product Manual

Page 9 of 15
6. Slide the height selection rings (12) over the bottom end of the oil pipe (10) and lock them into the
required position by tightening the two hex sockets grub screws using a 4.5mm hex key.
7. Insert the outlet of the oil pan (9) into the top of the ball valve assembly (8). Ensure that it is fully
seated and secure it by tightening the 5mm hex socket screw in the side of the collar. The oil pan
is not locked in place and can be rotated 360° as indicated in below picture.
Before Each Use
⚠WARNING
 Always wear the proper personal protective gear including ANSI Z87.1 compliant safety goggles
and heat-resistant rubber gloves when using this product.
 Use only on a dry, clean, level surface capable of supporting the weight of the vehicle.
 Engine exhaust contains carbon monoxide; an odorless, invisible gas that can cause injury or
death. Do not run the vehicle’s engine while using this product.
 Never work under a vehicle without the proper support devices. An incorrectly supported vehicle