Product Manual

Page 6 of 22
 Check for damaged parts before each use. Carefully check that the product will operate properly
and perform its intended function. Replace damaged or worn parts immediately. Never operate the
product with a damaged part.
 Do not use a product with a malfunctioning switch. Any power tool that cannot be controlled with
the power switch is dangerous and must be repaired by an authorized service representative
before using.
 Disconnect the power/air supply from the product and place the switch in the locked or off position
before making any adjustments, changing accessories, or storing the tool. Such preventive safety
measures reduce the risk of starting the tool accidentally.
 Store the benchtop grinder when it is not in use. Store it in a dry, secure place out of the reach of
children. Inspect the tool for good working condition prior to storage and before re-use.
 Use only accessories that are recommended by the manufacturer for use with your product.
Accessories that may be suitable for one product may create a risk of injury when used with
another tool. Never use an accessory that has a lower operating speed or operating pressure than
the tool itself.
 Keep guards in place and in working order. Never operate the product without the guards in place.
 Do not leave the tool running unattended.
Specific Operation Warnings
⚠WARNING
 Always wear eye protection.
 Only use accessories rated at least equal to the maximum speed marked on the benchtop grinder.
 Do not modify the benchtop grinder in any way.
 Do not wear gloves, jewelry, or loose clothing.
 Do not use a cracked or chipped grinding wheel.
 Bolt down the benchtop grinder before using.
 Do not use the benchtop grinder in the rain or in a damp location.
 Never reach to pick up a workpiece, a piece of scrap, or anything else that is in or near the
grinding path of the wheel.
 Never stand, or have any part of your body in line with the path of the wheel.
 Do not over tighten wheel nut. Excessive tightening can cause the wheel to crack during
operation.
 Always use the grinder’s wheel guards and safety shields.
 ONLY use a 40W lamp (not included).