Product Manual

Page 9 of 17
Assembly Instructions
⚠WARNING
 Disconnect the car polisher from the power supply.
 Do not operate the car polisher with one hand only or without the side handle properly installed.
Installing the Side Handle
The side handle can be installed on the left or right side of the gear housing. Screw the threaded end
of the side handle into the selected position. Tighten securely before beginning work.
Installing a Threaded Accessory
1. The accessory MUST be:
 Rated to at least 6,400 OPM.
 No larger than 6'' (150mm) in diameter.
 Fitted with a threaded opening of 5/16'' - 24 UNF, undamaged.
 Compatible with the car polisher, i.e., the sanding disc, polishing bonnet, or foam pad and
backing pad. (The sanding disc and polishing bonnet are sold separately.)
2. Use the included wrench to prevent the spindle from turning.
3. Thread the disc accessory firmly onto the spindle.
4. Remove the wrench before use.