Product Manual

6 of 11 7 of 11
5FT. x 8FT. HD TRAILER WITH 5.30-12 TIRES
OWNER’S MANUAL
STEP 6
1. Assemble tail light bracket (#23) to the end of left and right side rail (#1L, 1R) using M10*25
BOLT, ￠10 FLAT WASHER and M10 NUTS (#A,C,B). Install license plate holder (#13) with left
tail light (#21) to left side rail (#1L) using supplied hardware. Note: Left tail light is with a clear
window. Install right tail light (#22) to right side rail.
2. Open the lens of side running light (#25) by coin with 4mm self tapping screw (#S) and run
wire lead through the center hole to find wire to side rail then cover with the lens .
5FT. x 8FT. HD TRAILER WITH 5.30-12 TIRES
OWNER’S MANUAL
TRAILER LIGHT AND WIRE ASSEMBLY INSTRUCTIONS
WIRING DIAGRAM AND INSTRUCTION
1.
Check alignment of all parts and install the 4-wire vehicle connector in the trunk area of your car.
2. Locate the connector plug near the hitch ball and lay out wires.
3. Connect the white wire to the frame or body of the car;
4.
Connect the brown wire to the tail light by stripping, wrapping, and taping connector; similarly
connect the yellow wire to the left signal and stop light wire and the green wire to the right
signal and stop light wire. NOTE: Some foreign vehicles may require an adapter to convert
their 5-wire system to the wire vehicle connector.
1. Attach white ground wire at plug end of wiring harness to the small hole on coupler base
(#15) with 4mm tapping screw.
2. Leave about 18” of wire beyond the coupler and lay out wire on the inside to the channel of
tow bar and side rail as shown. Holes wire to rail with wire clip as circle D.
3. Connect the wire lead from the side running light to the brown wire on each side with the wire
connector. Use pliers to squeeze the connector closed as circle E.
Strip end of wire 3/4” for yellow / brown and green / brown wires.
Make tail light connections as per color code with connector as circle C .
Left Side
Yellow – Red wire
Brown – Two black wires
Right Side
Green – Red wire
Brown – Two black wires