Product Manual
4 of 11 5 of 11
4. Insert COTTER PIN (#T) through the hole at the end of spindle
and bend pin over to lock. Gently tap dust cap (#29) over hub
opening until flange on cap seats on hub .
STEP 3:
1. Attach tow bar (#5) to side rail (#1L, 1R) to cross member (#2). Note: tow bar with three holes
is toward the front. Secure with M10*25 BOLT, ¢10FLAT WASHER and M10 NUTS (# A,C,B )
as shown.
2. Place stand base (#16) on the front of tow bar (#5), secure with six holes by M10*25 BOLT, ¢
10FLAT WASHER and M10 NUTS (# A,C,B ) as shown.
5FT. x 8FT. HD TRAILER WITH 5.30-12 TIRES
OWNER’S MANUAL
5FT. x 8FT. HD TRAILER WITH 5.30-12 TIRES
OWNER’S MANUAL
STEP 4:
1. Turn over the trailer assembly.
2. Attach spare tire bar (#6) to the “U “ channel of tow bar and put the coupler base (#15) on the
tow bar as shown, secure with M10*25 BOLT, ¢10FLAT WASHER and M10 NUTS (# A,C,B ) .
3. Install coupler (#14) to coupler base (#15). Attach safety chain (#17) to the coupler (#14) with
an M12*40 bolt inserted through the center link of the safety chain in place, using a ¢12 flat
washer and M12 nylon nut (#O,L,K). Using two M12*90 BOLT go through the side wall hole of
coupler and coupler base then lock with M12 FLAT WASHER and M12 NYLON LOCK NUT (#I,
L, K) as shown. Insert M12*20 BOLT with M12 FLAT WASHER to the top hole of coupler (#14)
then lock with M12 NYLON LOCK NUT (#J, L, K ). Place coupler with coupler base (#14, 15)
on the front of the tow bar, secure with six holes by M10*25 BOLT, ¢10FLAT WASHER and
M10 NUTS (# A,C,B ) as shown.
4. Lock coupler trigger using safety pin (#N) through the trigger
hole then insert the 2mm R pin (#Q) through the end hole of
safety pin (#N) to lock the coupler.
STEP 5:
1. Mount fender bracket A (#30) to the left side rail (#1L) using M10*25 BOLT , ¢10FLAT
WASHER and M10 NUTS (# A,C,B ) and mount fender bracket B (#31) to the right side rail
(#1R) using M10*25 BOLT , ¢10FLAT WASHER and M10 NUTS (# A,C,B ) as shown. Note:
Fender bracket A and B are mirror image each other. Install fender (#11) to fender bracket A
and B (#30,31) using M10*25 BOLT , ¢10FLAT WASHER and M10 NUTS (# A,C,B ) as shown .
2. Tighten the M12 HUB LUG NUT (#M) with socket or lug wrench to 90 ft/lbs.
Caution: Periodically add grease as needed to the grease fitting.