Product Manual

Page 7 of 13
store this product near open flames or other heat sources.
 Remove this product and clear the work area before lowering the vehicle.
 Used engine oil is toxic and should be properly disposed of or recycled.
 Do not use with corrosive or flammable fluids.
 Not for use by or around children.
Main Parts of Product
Part Number Reference
Description
Quantity
1
Caster Kit
1
2
Wheel Kit
1
3
Regulator Kit
1
4
Locking Knob Kit
1
5
Bowl Kit
1
6
Bowl & Ext Tube Kit
1
7
Drain Hose Kit
1
8
Tank
1
Assembly Instructions
1. Connect the Bowl Kit (5) to the Bowl & Ext Tube Kit (6).
2. Connect the Installed Bowl Kit (5) and the Bowl & Ext Tube Kit (6) to the Locking Knot Kit
(4).
3. Install the Drain Hose Kit (7) under the situation of turning off the Regulator Kit (3).
Before Each Use
⚠WARNING
 Always wear the proper personal protective gear including ANSI Z87.1 compliant safety goggles
and heat-resistant rubber gloves when using this product.
 Use only on a dry, clean, level surface capable of supporting the weight of the vehicle.
 Engine exhaust contains carbon monoxide; an odorless, invisible gas that can cause injury or
death. Do not run the vehicle’s engine while using this product.
 Never work under a vehicle without the proper support devices. An incorrectly supported vehicle
can tilt or fall and cause injury or death.
 Check for damaged parts before each use. Carefully check that the product will operate properly
and perform its intended function. Replace damaged or worn parts immediately. Never operate the
product with a damaged part.
 Hot oil can cause severe burns. Allow the engine oil to cool down completely before pumping the
oil.