Product Manual

21
Figure 9-4
12. Connect front corner running lights to the brown harness wires with plastic wire connectors. Use pliers to
squeeze connectors closed. See figure 9-5.
Figure 9-5
13. Use push on wire clips to fasten wires to the lower flange of the rails and cross members of the trailer.
Verify that there is adequate harness to fold the trailer and tow bar.
14. Cut the yellow/brown and green/brown wires to the appropriate lengths and strip wire ends back ¾ inch.
15. On the right side of the trailer, connect the green wires together and the brown wires together with wire
nuts. See figure 9-6.
16. On the left side of the trailer, connect the yellow wires together and the brown wires together with wire
nuts. See figure 9-6.
Right Side Figure 9-6 Left Side
STEP 10
The 3/4 inch plywood and hardware for the trailer floor are not included with your trailer. This step indicates
the drilling locations for the hardware. Drill all holes with a high speed drill bit. Use 3/8in. flat washers, lock
washers and hex nuts to mount floor tight to trailer frame. See figure 10-1.