Product Manual

15
Figure 6-1
2. Remove hub cap (21) using a small pry bar between the flange on the hub cap and the face of the hub.
3. Remove 4mm cotter pin (L), bearing (20) and washer (N). See figure 6-2.
Figure 6-2
4. Remove castle nuts (H) from axle ends.
5. Carefully slide tire/hub assembly onto axle with lug nuts facing outward.
6. Install outer bearing with the taper facing inward toward the hub.
7. Install the washer and castle nut (H). Tighten castle nut while turning the tire/hub. Tighten castle nut until
there is resistance while turning the tire/hub.
8. Install 4mm cotter pin (L) through castle nut (H) and hole in axle end. If holes are not aligned, slightly
loosen castle nut no more than one castellation to align holes.
9. Spread cotter pin (L) to retain castle nut. See figure 6-3.
10. Pump approximately 8-10 pumps of a hand grease gun into hub.