Product Manual

Page 11 of 17
Operating Instructions
 To start the tool, press the trigger. The more the trigger is pressed, the faster the tool runs.
To stop the tool, release the trigger.
 To switch between forward and reverse, flip the lever near the trigger to F (forward) or R
(reverse).
After Each Use
 Disconnect the air supply from the tool.
 If you are not using a lubricated air supply, lubricate the tool.
 Store the tool.
Maintenance
WARNING: To avoid risk of severe injury, disconnect the air supply from the tool
before performing any maintenance, cleaning, or inspection.
Maintain your tool. It is recommended that the general condition of any tool be examined before it
is used. Keep your tool in good repair by adopting a program of conscientious repair and
maintenance in accordance with the recommended procedures found in this manual. Keep all
cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less
likely to bind and are easier to control. Keep handles dry, clean, and free from oil and grease.
Cleaning. Use only soap and a damp cloth to clean your tool. Many household cleaners are
harmful to plastics and other insulation. Never let liquid get inside the tool.
Troubleshooting
If any abnormal vibrations or noise occurs, immediately turn the tool off and have the problem
corrected before further use. Have necessary repairs made by qualified service personnel.