Product Manual
Page 12 of 22
Before Each Use
⚠WARNING
Never use the pressure washer to draw in water contaminated with solvents (e.g. paint thinners,
gasoline, oil, etc.).
Dirt in the water inlet will damage the pressure washer. To avoid this risk, we recommend
inspecting and cleaning water inlet regularly.
Always prevent debris from being drawn into the washer by using a clean water source and an
additional accessory water filter if required.
To prolong the life of the washer, rest the washer for 5 minutes after every 30 minutes of use.
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects that could create a
hazard. Remove any objects from the work area that could be tripped over, such as toys or outdoor
furniture. Ensure that all doors and windows are closed tightly.
Water Supply (Cold Water Only)
Only draw cold water through the washer. For use with a cold water supply only. The water hose must
be at least a 1/2" (13 mm) in diameter. The flow rate of the water supply must not fall below 2 GPM
(gallons per minute). The flow rate can be determined by running the water for one minute into an
empty 5-gallon container. Measure the volume of water in the bucket after one minute. The water
supply temperature must not exceed 104°F (40°C).
Operating Instructions
Adjustable Spray Nozzle
The adjustable spray nozzle can be adjusted from fan to jet. The spray is adjusted by turning the
nozzle.
Working with Detergents
⚠WARNING
Before starting any cleaning task, it is important to inspect the area for objects that could create a
hazard.
Remove any objects from the work area that could be tripped over, such as toys or outdoor
furniture. Ensure that all doors and windows are closed tightly.
Damage may occur to painted surfaces if chemical is allowed to dry on the surface. Wash and
rinse a small section at a time. Avoid working on hot surfaces or in direct sunlight.
Never use: Bleach, chlorine products and other corrosive chemicals, liquids containing solvents
(i.e., paint thinners, gasoline, oils), tri-sodium phosphate products, ammonia products, or acid-
based products. These chemicals will harm the pressure washer and will damage the surface
being cleaned.