Product Manual

Page 7 of 11
To Inflate Tires
1) Attach the valve adaptor to the inflator’s rubber hose and lock.
2) Insert the plug power cord into the 12 volt cigarette lighter and start the car engine to save battery
charge.
3) Regularly check the tire pressure with another tire pressure gauge.
4) When the pressure level is correct, stop the engine, unplug the power cord, and remove the
inflator valve.
To Inflate Plastic Items
1) Place the conical nozzle in the inflator valve.
2) Be cautious: small items inflate faster than car tires.
After Each Use
WARNING
Only hold the unit by the carry handle and allow the unit to cool before storing.
Store the product in a dry location.
Troubleshooting
Failure
Possible Cause
Corrective Action
Product stops
during operation.
Low voltage.
Check the battery condition.
Protective circuit activates.
Disconnect the power and wait for the
product cool down.
Air leaking.
Brass inflator is not fully extended.
Fully extend the brass inflator.