Product Manual

SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY CONSIDERATIONS
• If mounting this product requires drilling holes, the installer MUST be sure that no
vehicle components or other vital parts could be damaged by the drilling process.
Check both sides of the mounting surface before drilling begins. Also de-burr any
holes and remove any metal shards or remnants. Install grommets into all wire
passage holes.
• Do not use a pressure washer to clean this product.
Utility Light USE AND CARE
• Do not modify the Utility Light in any way. Unauthorized modification may
impair the function and/or safety and could affect the life of the product.
• Always check damaged or worn out parts before using the Utility light.
Broken parts will affect the Utility light operation. Replace or repair damaged or
worn parts immediately.
INSTALL THE LAMPS
• TOOLS NEEDED: Phillips screw driver #2, Crescent wrench, Pliers, Wire cutter,
Electrical drill w/ 1/8”, 5/16” bits.
• Select a mounting location”” that will give you a maximum beam adjustment range
and will not cause any obstruction for your vehicle’s normal functions.
• Mark the mounting position of the lamps onto the surface. You may either upright
mount or pendant mount the lamps, but always have the small vent opening on
the housing face down. *Hint: Point the lens straight forward or at a 0~5 degree to
the center to get the optimum illuminating light beam.
• Attach the light units to their marked positions and secure the bracket/pedestal
with the supplied screws. If the mounting screws are not accessible with the whole
light unit on, disassemble the bracket/pedestal from the light unit and bolt it to the
mounting surface, then mount the lamp to the bracket/pedestal. Do not over
tighten the screws.
• For those hard-to-mount locations, use the adhesive tapes to attach the