Product Manual

Page 6 of 11
Main Parts of Light
Subassembly
Light Bar
Bracket and Hardware
Tools for Assembly
Assembly Instructions
NOTE:
Do not install this device such that it impairs the effectiveness of the original regulated vehicle lighting
equipment per the requirements of 49 CFR Part 571.
INSTALL THE LIGHT BAR (see Parts List for references below):
1. Mount the bracket (part #2) on the side of the lamp body (part #1) with an M5 x 8 Hex socket cap
screw (part #3). Tighten the screws with the wrench (part #7). Refer to images 1, 2, and 3 for
reference.
2. Install the bracket on the other side according to step 1. Refer to images 1, 2, and 3 for reference.
3. Mount the bracket (part #2) on the vehicle using an M5 x 25 hex socket cap screw (part #4) and
an M5 hex nut (part #5). Tighten the screws with the wrench (part #7). Refer to images 4, 5, and 6
for reference.
4. Install the bracket on the other side according to step 3. Refer to images 4, 5, and 6 for reference.
5. Connect the pigtail to the wire harness. The red wire is connected to the positive pole and the
black wire is connected to the negative pole.