UFO Tilt Mount Installation Manual

TILT MOUNT INSTALLATION MANUAL - 6© 2016 IRONRIDGE, INC. VERSION 1.10
5. SECURE MODULES
A. SECURE FIRST END
Place rst module in position on rails, a minimum of 1”
from rail ends. Snap Stopper Sleeves onto UFO. Fasten
the module to the rail with the UFO, ensuring that the UFO
is hooked over the top of the module. Torque to 80 in-lbs.
í Ensure rails are square before placing modules.
í Hold Stopper Sleeves on end while torquing to prevent rotation.
B. SECURE NEXT MODULES
Place UFO into each rail, placing them ush against rst
module. Slide second module against the UFO. Torque to
80 in-lbs. Repeat for each following module.
í When reinstalling UFO, move modules a minimum of 1/16" so
UFOs are in contact with a new section of module frame.
í If using Wire Clips, refer to Page 8.
C. SECURE LAST END
Place last module in position on rails, a minimum of 1”
from rail ends. Snap Stopper Sleeves onto UFO. Secure
UFO on rail, ensuring it is hooked over the top of the
module. Torque to 80 in-lbs.
í Hold Stopper Sleeves on end while torquing to prevent rotation.
í Repeat all steps for each following row of modules.
C
A
B
1" From
Rail End
UFO
(80 in-lbs)
UFO
(80 in-lbs)
Stopper
Sleeve
UFO
(80 in-lbs)