UFO Tilt Mount Installation Manual

TILT MOUNT INSTALLATION MANUAL - 9© 2016 IRONRIDGE, INC. VERSION 1.10
MICROINVERTER KITS
Torque to
80 in-lbs
SYSTEMS USING ENPHASE MICROINVERTERS
Use IronRidge's Microinverter Kit to bond compatible
microinverters and power optimizers to the racking system.
Insert Microinverter Kit T-bolt into top rail slot. Place
compatible microinverter or power optimizer into position
and tighten hex nut to 80 in-lbs.
COMPATIBLE PRODUCTS
Enphase - M250-72, M250-60, M215-60, and C250-72
Darfon - MIG240, MIG300, G320, G640
Solar Edge - P300, P320, P400, P405, P600, P700, P730
IronRidge systems using approved Enphase products eliminate the need for lay-in lugs and eld installed equipment
grounding conductors (EGC). This solution meets the requirements of UL 2703 for bonding and grounding and is included
in this listing.
The following Enphase products are included in this listing: Microinverters M250-72, M250-60, M215-60, C250-72, and
Engage cables ETXX-240, ETXX-208, ETXX-277.
í A minimum of two inverters mounted to the same rail and connected to the same Engage cable are required.
í The microinverters must be used with a maximum 20 A branch rated overcurrent protection device (OCPD).