Datasheet

BI 7.2.3-45 Jul-2017, Rev 1
Instructions: QMTRF - Tile Replacement Flashing
Installation Tools Required: tape measure, aviation type tin snips, chalk or crayon, roofing bar.
NOTE: Installation method is the same for all tile replacement flashing profiles.
1
WARNING: Quick Mount PV products are NOT designed and should NOT be used for anchoring fall protection equipment.
8
Remove a tile and install the tile hook of your choice to a
rafter. Properly  ash the hook using prefered method.
Prop up adjacent tiles to the side and above using roo ng
bars.
Place the Tile Replacement Flashing matching the roof's
tile pro le over the mount and measure or mark o the
position of the tile hook at the bottom edge of the  ash-
ing.
1
2
Using a pair of tin snips, make two cuts to the bottom edge
of the  ashing and bend the tab up, creating a space for
the tile hook to pass through.
3
4
Place the cut Tile Replacement Flashing back over the
hook in place of the original tile. For replacement  ashings
susceptible to movement, adhere  ashing to adjacent
tile, using roo ng adhesive compatible with contacted
materials and environmental conditions, according to the
TRI Guidelines (see sections MC-21 & MC-24).