FX Rail-Less Installation

FX SYSTEM INSTALLATION MANUAL - 18© 2018 IRONRIDGE, INC. VERSION 1.50
7. WIRE MANAGEMENT
A. PLACE WIRES IN TROUGH
Insert microinverter or power optimizer cables into the wire
management trough on Mount FX by holding the wire clip
up and sliding the cables in.
 The wire management trough on Mount FX can hold up to one
12mm trunk cable, or two PV cables, or four USE-2 wires.
 Mount FX utilizes wire clips that maintain tension but do not
cause any damage to the surface of wire insulation.
 Wire management clips can also be used to attach PV or USE-
2 wires to the bottom leg of the module frames. This should be
done before installing modules on the array in order to reduce
work on the roof.
SAMPLE WIRING LAYOUT
Clip wires to inside of modules