FX Rail-Less Installation

FX SYSTEM INSTALLATION MANUAL - 13© 2018 IRONRIDGE, INC. VERSION 1.50
4. INSTALL TRIM FX AND BRIDGE FX
B. CONNECT TRIM FX TO BRIDGE FX
Connect the second trim to the bridge using the same
method. Repeat for remaining trim and bridge assemblies.
 Always position the ends of Trim FX so that it is centered between
alignment markers.
 The distance between one Bridge FX bolt spacer to the next
should equal the module dimension being installed.
C. INSTALL END CAPS
Install one End Cap on each end of the connected length
of Trim FX (running E-W along the bottom of the array).
B
5. INSTALL MODULES
A. PLACE FIRST MODULE
Place the rst module in the clamp of the mount and
bridge, checking to ensure that the module edge is ush
with the spacer on the bridge.
Rotate the module downward and apply pressure towards
the mount and bridge to ensure that module slides into
place and is properly seated.
 Use the spacer on Bridge FX to ensure that modules are properly
aligned.
A
Fully seated