GripCap+ install Manual

Installation

FV-GCP-01-YX-MAN REV 1.1

Insert lag bolt with new bonded washer through

Cap and flashing. Tighten lag bolt until fully

seated. FlashVue with GripCap+ is now

installed and ready for IronRidge XR Rails.

Tools Required: FlashVue Flashing and Lag, tape measure, chalk, approved sealing materials, driver with 1/4”

bit and 7/16” hex socket

Locate rafters and snap vertical and horizontal lines

to mark locations of flashings. Drill 1/4” pilot holes,

then backfill with roofing manufacturer’s approved

sealant.

Press GripCap+ onto flashing in desired orientation

for E/W or N/S rails. If needed, remove FlashVue

GripCap, re-backfill pilot hole, and replace EPDM

backed washer on lag with new one.

Slide flashing between 1st and 2nd course, so the top is

at least 3/4” above the edge of the 3rd course and the

bottom is above the edge of the 1st course. Line up pilot

hole with flashing hole.

1st course

2nd course

3rd course

Rafter

Attach rails to either side of the open slot using

bonding hardware. Level rail at desired height, then

torque to 250 in-lbs (21 ft-lbs).

Torque to

250 in-lbs

Structural Certification

Designed and Certified for Compliance with the

International Building Code & ASCE/SEI-7.

Water Seal Ratings

Water Sealing Tested to UL 441 Section 27

“Rain Test” and TAS 100(A)-95 “Wind Driven

Rain Test” by Intertek. Tested and evaluated

without sealant. Any roofing manufacturer

approved sealant is allowed.

UL 2703

Conforms to UL 2703 Mechanical and Bonding

requirements. See Ironridge Flush Mount

Installation Manual for full ratings.