GripCap+ install Manual

GripCap+

FV-GCP-01-YX-MAN REV 1.1

NO.

DESCRIPTION

WASHER, EPDM BACKED, 5/16"

ASSY, GRIPCAP+

WEIGHT:

SHEET 1 OF 1

SIZE

SCALE:1:2

DO NOT SCALE DRAWING

GRIPCAP+, FLASHVUE

0.3 lbs

1 2

2.11

2.28

3.79

PAGE 1
GripCap+ 2.28 2.11 3.79 1 NO. DESCRIPTION 1 WASHER, EPDM BACKED, 5/16" 2 ASSY, GRIPCAP+ © 2020 IronRidge, Inc. All rights reserved. Visit www.ironridge.com or call 1-800-227-9523 for more information. 2 GRIPCAP+, FLASHVUE SIZE A SCALE:1:2 DO NOT SCALE DRAWING WEIGHT: 0.3 lbs SHEET 1 OF 1 FV-GCP-01-YX-MAN REV 1.
PAGE 2
Installation Tools Required: FlashVue Flashing and Lag, tape measure, chalk, approved sealing materials, driver with 1/4” bit and 7/16” hex socket 2 1 3rd course Rafter 2nd course 1st course Locate rafters and snap vertical and horizontal lines to mark locations of flashings. Drill 1/4” pilot holes, then backfill with roofing manufacturer’s approved sealant. 3 Press GripCap+ onto flashing in desired orientation for E/W or N/S rails.