Installation Guide

Trench
Link panels
Press into soil
NO ADDITIONAL PARTS REQUIRED FOR INSTALLATION
Mark out the outline of the plant bed or lawn edge
using a straight spade or shovel. This will give you a
definite place to set the Press & Go edging and allow
for a faster installation.
Press & Go Edging is flexible and allows for curved
installation as well as bending to create corners.
Once your project is outlined with the spade or shovel,
pressing the edging into the soil takes very little effort.
1
Slide the top tab of the second panel into the square
opening of the installed piece. Using and flat-head
screwdriver,
2
bend the locking tab through the keyhole
to connect the pieces