Installation Guide

ManualsBrandsIroncraft ManualsFence Posts(Common: 2-in x 3-3/8-in x 4-ft; Actual: 2-in x 3.7-in x 4.2-ft) Euro Black Powder Coat Steel Decorative Metal Fence Universal Post

Euro Fence Installaon Instrucons

STEP 1: PLAN YOUR DESIGN

Decide on your layout and remember to consider where the gate will be installed. Regular posts should be

set 72” apart, measuring from center to center of each post, while gate posts should be set 48” apart,

center to center.

Layout the perimeter of determined fencing area with stakes and masons string to keep posts in line when

installing. Place the wood stakes where you intend on installing the posts.

Post Post

72”

Center of Post

POSTS FOR PANELS

Post Post

48”

Center of Post

POSTS FOR GATES

REQUIRED TOOLS:

PLEASE NOTE: Addional accessories are required if installing on hard surface, such as a deck, or

if mounng the end panel to a wall. Please consult with your local store for informaon regard-

ing the necessary materials.

HAMMER

TAPE

MEASURER

MASONS

STRING

2” x 2”

WOOD

STAKES

SHOVEL

WHEEL

BARROW

DRILL

PHILLIPS

SCREWDRIVER

WOOD

BLOCKS

ADJUSTABLE

WRENCH

HANDHELD

SAW

POST HOLE

DIGGER

CONCRETE

HEX

WRENCH

RECIPROCATING

SAW

IronCra Customer Service

1-888-662-1788

Monday - Friday

8am - 5pm EST

Summary of content (4 pages)

PAGE 1
IronCraft Customer Service 1-888-662-1788 Monday - Friday 8am - 5pm EST Euro Fence Installation Instructions REQUIRED TOOLS: MASONS STRING 2” x 2” WOOD STAKES SHOVEL POST HOLE DIGGER CONCRETE PHILLIPS SCREWDRIVER WOOD BLOCKS ADJUSTABLE WRENCH HEX WRENCH TAPE MEASURER HAMMER WHEEL BARROW DRILL HANDHELD SAW RECIPROCATING SAW PLEASE NOTE: Additional accessories are required if installing on hard surface, such as a deck, or if mounting the end panel to a wall.
PAGE 2
STEP 2: POST INSTALLATION Starting with the ﬁrst post, remove the stake from the ground and dig a hole measuring approximately 8” in diameter and around 22“ deep in the stakes place. Once the hole is dug, position the post in the hole and check to make sure the pre-cut holes are facing the direction the panels will be installed. Using a hammer and a block of wood (to protect the post) hammer the post into the ground approximately 2-1/2” so the post is 24-1/2“ below ground level.
PAGE 3
CORNER PANELS If installing on a corner, holes must be drilled on the appropriate side to make a 90° angle. When drilling, make sure they are aligned with the pre-drilled dimples. Once holes are drilled, install panels in the same manner as GATE INSTALLATION 8.75” - Top Post Hinge (40.
PAGE 4
LATCH INSTALL Attach latch and striker to post and gate at preferred height using self tapping screws. CUTTING PANELS When you reach an area that is shorter than 72” wide, you can cut the panels using a hand saw or reciprocating saw to the desired width. Measure the distance between the two posts to get the size for the short panel. The panel must be cut in 1-7/8” increments ending with a vertical wire. Once panel has been cut, touch up ends with exterior quality black paint to help prevent rusting.